Additive Manufacturing of Metals and Alloys
MSE-666
This file is part of the content downloaded from Additive Manufacturing of Metals and Alloys.
- Chapter 1 - Introduction (File)
- Chapter 2 - Powder fabrication and characterization (File)
- Chapter 3.1 - Beam-material interaction (File)
- Chapter 3.2 - Heat flow in the material (File)
- Chapter 4 - Introduction into rapid solidification (File)
- Chapter 5 - Residual stress, pores, cracks, and surface roughness (File)
- Chapter 6.1 - AM of Ti, steels, Cu and precious alloys (File)
- Chapter 6.2 - AM of Ni alloys (File)
- Chapter 6.3 - AM of Al alloys (File)
- Chapter 7 - Microstructure control through processing (File)
- Chapter 8 - Post-treatments for microstructure and properties control (File)
- Chapter 9 - Mechanical properties (File)
- Chapter 10 - Properties of AM lattice structures (File)
- Chapter 11 - AM of special metals & multi-material AM (File)
- Supplementary Chapter (File)